Comments on: Wire Feed Welding Machines

By: REVIEW IT BEFORE YOU BUY IT!!!

REVIEW IT BEFORE YOU BUY IT!!! — Fri, 28 Jan 2011 12:17:03 +0000

**YOUTUBE VIDEO REVIEWS ON THE HOTTEST ELECTRONICS OUT**…

#1 SITE FOR THE LATEST REVIEWS ON THE HOTTEST TECHNOLOGY HITTING THE MAINSTREAM!…

By: SHOP ELECTRONICS!!!

SHOP ELECTRONICS!!! — Sun, 16 Jan 2011 19:59:14 +0000

**YOUTUBE VIDEO REVIEWS ON THE HOTTEST ELECTRONICS OUT**…

#1 SITE FOR THE LATEST REVIEWS ON THE HOTTEST TECHNOLOGY HITTING THE MAINSTREAM!…

By: knallerten69

knallerten69 — Sat, 10 Jan 2009 08:52:43 +0000

JEG SER DENNE I KLASSA NÅ!!!!!!!!

By: FarmMachinist

FarmMachinist — Sat, 10 Jan 2009 07:27:50 +0000

pull … deeper penetration …. push … less penetration.

pull … puts more heat into the weld puddle.

push … puts less heat into the weld puddle.

This isn’t always the case though … uphill & downhill are the exactly opposite. Uphill digs deeper where as downhill doesn’t.

When your practicing … don’t fill in you weld at the end … you can easily tell which methods penetrate deeper into the base metal.

By: hate work

hate work — Fri, 09 Jan 2009 17:42:16 +0000

Hope you are not using pure argon (just a wast of money for pure). You should be using a 75/25 mix of argon/co2. The shielding gas shields the molten metal from the atmosphere, more so oxygen and nitrogen to prevent porosity, and reduce the chance of cracks. To rent a tank you should call a local welding supply for the prices as the price varies quit a bit by location. I am in Ohio so a price I would give you would not be true for your location.
Here is a good site to look at, http://www.weldingtipsandtricks.com/index.html
http://www.weldingtipsandtricks.com/Mig-welding-tips.html

(32 years welding)

By: Linchpin

Linchpin — Fri, 09 Jan 2009 16:45:57 +0000

If the nozzle is arcing it means the insulator between the nozzle and gas diffuser is probably shot. You will have to either replace the insulator or make sure you don't touch the work piece.
Arcing outside the weld zone is not good, can lead to inbrittlement and cracking.
Oh, and good job on buying a miller…i hate it when people buy crap gear and expect miracles(or ask me to perform them with their junk welder)

By: ArizonaAdventures

ArizonaAdventures — Fri, 09 Jan 2009 14:31:25 +0000

very nice video

By: Tushar

Tushar — Fri, 09 Jan 2009 07:21:12 +0000

Consistency, quality, and operating cost. Remember, you don't need highly trained welders, just machine operators to run them.

By: gownozjad3

gownozjad3 — Fri, 09 Jan 2009 05:30:10 +0000

Im beginer.When Im welding Icant see difference between push and pull, In structure of weld.But I have only cupple hours of welding on my account:) Thank you

By: lassehoei

lassehoei — Thu, 08 Jan 2009 16:24:20 +0000

must i use welding gogles when seeing the video !!!! thxs???